Yea. I just need to get back to V1.02. Hopefully Tentec can accommodate
this.
Steve N4LQ
----- Original Message -----
From: "Paul Christensen" <w9ac@arrl.net>
To: <tentec@contesting.com>
Sent: Saturday, August 21, 2004 1:01 PM
Subject: Re: [TenTec] Omni VI+ firmware rev.
> > Note: All the above is with firmware ver. 1.03. I have no idea what 1.02
> > does but apparently it does key faster.
>
> QSK with V1.02 is pretty damn fast as long as plug 52 is removed on the
> IF/AF circuit board.
>
> -Paul, W9AC
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|