No Eric. There's really no need to talk to anyone about it. The Inrad
filters are almost always shielded, so it's no surprise. If I were to modify
the filter cover, I would simply cut off the portion of the cover that is
supposed to keep the Inrad filter in place.
It's really no big deal, as I said, the filters plug into the filter board
in the top section of the radio and certainly should have no reason to ever
be jiggled loose from their board. Most of the older Ten Tec gear, the
filters were installed in the bottom section of the rig, and a filter cover
was certainly needed in that case, to keep them in place.
How do you have the fortitude to sit there with that nice radio, and not
open the box?
Tom - W4BQF
----- Original Message -----
From: "Eric Rosenberg" <wd3q@starpower.net>
To: <tentec@contesting.com>
Cc: <INRAD@rosenet.net>; "Tommy" <aldermant@alltel.net>
Sent: Saturday, August 14, 2004 10:03 PM
Subject: [TenTec] Re: TenTec Digest, Vol 20, Issue 59
> Tom --
>
> I (still) haven't opened up the box.
>
> How would you modify the filter cover, and have you spoken to INRAD
> about this?
>
> Eric W3DQ
>
>
> At 01:49 PM 8/14/2004 -0400, you wrote:
> >From: "Tommy" <aldermant@alltel.net>
> >Subject: Re: [TenTec] Inrad 762
> >Date: Sat, 14 Aug 2004 13:15:56 -0400
> >To: <tentec@contesting.com>
> >
> >Tody,
> >
> >I concur with Bill's writting's. I didn't have the 1.8kc filter in my
> >Orion,
> >so I moved the 1kc filter into the 1.8kc slot, put the 600hz filter
> >into the
> >1kc slot, and left the 500hz and 250hz filters installed and enabled.
> >Really
> >sounds quite impressive, especially in this CW contest going on this
> >weekend.
> >
> >The Inrad filter is almost a half an inch taller than the TT filters,
> >but I
> >did put the cover back over the filters, but just did not tighten it
> >down
> >fully. If I was going to keep my Orion, I would modify the filter
> >cover.
> >
> >Tom - W4BQF
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|