In Dxbase 2005 set the following parameters;
Baud Rate -> 57000
Word Length -> 8 bits
Parity -> None
Stop Bits -> 1
CTS checked high (DTR High and RTS High are not checked with the computer's
serial card set to the following:
Serial port to 57000, 8 bits, no Parity, 1 stop bit, Flow control set to
hardware --- Before the rest of you flame me and telling me that the
computer detects and sets up its serial port, remember that not all computer
serial ports are created equal.
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Sherman Banks
Sent: Tuesday, August 03, 2004 21:51
To: Ten Tec
Subject: [TenTec] DXBase Setup
Can someone email me the settings for the serial port setup in DXBase for
the Orion?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|