Mark,
I cannot reproduce your audio problem either. My guess is you have some
setting set to a different value then other people that is necessary for the
problem to show.
73,
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Mark Erbaugh" <mark@microenh.com>
To: <tentec@contesting.com>
Sent: Thursday, July 29, 2004 2:11 PM
Subject: Re: [TenTec] Orion loss of audio
> Toby,
>
> Thanks for the test.
>
> I am able to reproduce the situation repeatably. I can also lose audio by
> just pushing A>B several times, and or varying the length of time that I
> hold it down.
>
> I just turned the Orion off and back on and the condition is still there.
> This time I observed that the S-Meter is still active so it appears that
the
> receiver is still working, just no audio.
>
> I had all audio (left, right, speaker) routed from the main receiver.
>
> 73,
> Mark
>
> ----- Original Message -----
> From: "Toby Pennington" <toby423@earthlink.net>
> To: <tentec@contesting.com>
> Sent: Thursday, July 29, 2004 9:48 AM
> Subject: Re: [TenTec] Orion loss of audio
>
>
> > Mark, I tried to duplicate your loss of audio by holding down the A>B
> > button but on my Orion the audio does not go away but remains stable.
> Toby
> > W4CAK
> >
> > ----- Original Message -----
> > From: "Mark Erbaugh" <mark@microenh.com>
> > To: <tentec@contesting.com>
> > Sent: Thursday, July 29, 2004 9:32 AM
> > Subject: [TenTec] Orion loss of audio
> >
> >
> > > A while back, there was discussion on the reflector about complete
loss
> of
> > > Orion receive audio. Was this ever resolved?
> > >
> > > I have found a repeatable way to lose and recover the main receiver
> audio.
> > > The behaviour indicates it may be a glitch in the firmware.
> > >
> > > I was listening to 40m CW on the main receiver connected to VFO A. By
> > > pushing down and holding the A->B button for a second or two I can get
> the
> > > audio to go completely away (I am also monitoring the audio on the
Left
> > > output on the rear AUX I/O via my computer and that goes away also).
By
> > > pushing the A->B button I can get the audio to come back. I'm running
> > > firmware version 1.371.
> > >
> > > 73,
> > > Mark, N8ME
> > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > >
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|