Hi, Doc--
I don't know if my cautionary note applies to the 260 but doubt it. If the
supply has two pass transistors on the rear heat sink then it ought to be OK
as that is a characteristic of the newer ones (I think).
I had a very big deep cycle battery once and believe I ruined it by
overcharging it by leaving a charger connected for a long time. The charger
was "automatic" and was supposed to switch itself to trickle. Even so, the
battery went south. When that happened I decided to use a regular
automobile battery in the future but never used battery power after that so
can't compare the outcomes.
73, Mike N4NT
----- Original Message -----
From: "doc" <kd4e@verizon.net>
To: <tentec@contesting.com>
Sent: Friday, July 16, 2004 5:27 PM
Subject: Re: [TenTec] About Lou's "New" 262G Supply...
> Stuart Rohre wrote:
> > You used to be able to buy the add on over voltage boards for open frame
> > linear power supplies sold by a number of electronics companies. One of
> > those for a 12 volt supply would also work on Ten Tec supply outputs.
Look
> > for power supply vendors at distributors; one vendor is Power One.
> >
> > Stuart
> > K5KVH
>
> Does any of this apply to the 260?
>
> Just bought one recently, though I am unsure if I will be keeping
> it yet.
>
> I have a thought of using it as a floating charge across some
> large 12vdc deep cycle batteries to power my all-12vdc station.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|