John,
Put the antenna on the rx ant jack (don't forget to switch the ant switch)
and hook the antenna to it, if it receives fine on 40/30 meters then more
than likely there is something wrong with the relays on the low pass filter
board, probably K9 or K10..
Tim
NZ8J
----- Original Message -----
From: "John Mead" <w9ow@yahoo.com>
To: <tentec@contesting.com>
Sent: Wednesday, July 07, 2004 8:57 AM
Subject: [TenTec] Omni V Problem: 40 and 30 Meters went Dead
> I was operating my Omni V.9 when I noticed 40 meters
> had no RX or TX. I checked the other bands and found
> 30 meters was also out. The display on these bands is
> ok and I can hear very strong signals.
> Any suggestions would be really appreciated!
> John, W9OW
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|