Not really. Just follow the manual. And check to see if you need to move
the 'gain' jumper located near the filter board. Lot's of screws on the
bottom plate, but that's a good thing!
Tom - W4BQF
----- Original Message -----
From: "KZ2G" <kz2g@optonline.net>
To: <tentec@contesting.com>
Sent: Wednesday, July 07, 2004 7:25 AM
Subject: Re: [TenTec] Filters
> i'm thinking of installing the ten-tec 1.8 khz ssb filter in my Omni 6+.
> any things i should know about installing it? looks very easy according
to
> the manual.
>
> Bob, KZ2G --- 10-10 # 10148
> ----------------------------
> Omni 6 Plus (Base) & FT-90R (Wheelchair Mobile). C U on the air!
> See my Ham web at http://www.geocities.com/ram9872002/kz2g.htm
> Check out my Art Sale at
http://www.geocities.com/ram9872002/Artpage1.htm
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|