Hi Bruce,
Thanks for the offer, but $425 plus shipping is the lowest I'll go..
73
Tim
NZ8J
----- Original Message -----
From: "Bruce Sugarberg" <bsugarberg@core.com>
To: <tentec@contesting.com>
Sent: Tuesday, July 06, 2004 7:11 PM
Subject: Re: [TenTec] FS: Ten Tec Paragon
> Hi Tim,
>
> Would you take $400.00 for your Paragon?
>
> 73,
>
> Bruce Sugarberg WA8TNC
> =======================
> NZ8J wrote:
> > I still have the Paragon for sale. I put the original Ten Tec chip in it
but
> > will include the Ghiel chip as well. $425 plus shipping. Also have a 282
> > 250hz cw filter that I will sell to the Paragon buyer for an additional
$60.
> > I will not sell the filter until the Paragon sells. I have been
operating
> > the Paragon daily and it works fine.
> >
> > Would consider the Paragon plus some cash for a Pegasus..
> >
> > Thanks
> > Tim
> > Nz8J
> > ----- Original Message -----
> > From: "NZ8J" <nz8j@woh.rr.com>
> > To: <TenTec@contesting.com>
> > Sent: Friday, July 02, 2004 2:21 PM
> > Subject: [TenTec] FS: Ten Tec Paragon (reduced)
> >
> >
> >
> >>The previous buyer changed his mind, so it is for sale again at a
reduced
> >>price $425 + shipping... I'll be gone from email from this afternoon
until
> >>monday afternoon. Emails will be answered in order they are received.
> >>73
> >>Tim
> >>Nz8J
> >>----- Original Message -----
> >>From: "NZ8J" <nz8j@woh.rr.com>
> >>To: <TenTec@contesting.com>
> >>Sent: Wednesday, June 30, 2004 5:33 PM
> >>Subject: FS: Ten Tec Paragon
> >>
> >>
> >> I have a nice condition Ten Tec Paragon for sale (ser # 04B10081). It
> >
> > has
> >
> >>the Ghiel chip in it and I also have a new original Ten Tec chip. Comes
> >
> > with
> >
> >> a 500hz cw filter, original manual and power cord. It is about an 8
> >
> > overall
> >
> >> condition physically and works good electrically. I think the readout
> >>might
> >> be off by 50hz or so, but it's probably just the ref osc or BFO
> >
> > adjustment.
> >
> >> I have added the recommended mod to allow for QRP operation, the power
> >> output is from a little less than 1 watt to approximately 100 watts
> >> depending on the band. I have also disabled the amp relay so it
doesn't
> >> kick in and out when either sending cw or PTT on the mic (it would be
> >>easily
> >> enabled again with a drop of solder). It is all band transmit and is
> >
> > ready
> >
> >> for 60 meters. I can send pictures for those interested. Since it has
a
> >> couple of mods and the freq readout/BFO may need adjusting, I am
selling
> >
> > it
> >
> >> for $425 plus shipping.
> >> thanks
> >> Tim
> >> NZ8J
> >>
> >>
> >>
> >>_______________________________________________
> >>TenTec mailing list
> >>TenTec@contesting.com
> >>http://lists.contesting.com/mailman/listinfo/tentec
> >>
> >
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|