To: | tentec@contesting.com |
---|---|
Subject: | RE: [TenTec] ALC Indicator |
From: | "Richard Detweiler" <rdetweil@hotmail.com> |
Reply-to: | tentec@contesting.com |
Date: | Thu, 17 Jun 2004 08:45:08 -0500 |
List-post: | <mailto:tentec@contesting.com> |
Frank You may want to give Ten Tec Service a Call on these, I get ALC light all the time, It does take a little more drive but not problem to get the ALC to flash. On the Frequency problem, I had that happen one time in an earlier version of the firmware, I had the some how got the unit to think it was out of band on Main RX, Rather than display the frequency, the frequency went to the 000.000 like you showed. I sent in a ditnbits report on it, a new version came out and haven't seen it since. hope this helps 73's Rich K5SF From: Frank Skinner <f_skinner@yahoo.com> Reply-To: tentec@contesting.com To: tentec@contesting.com Subject: [TenTec] ALC Indicator Date: Thu, 17 Jun 2004 05:24:45 -0700 (PDT) _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] ALC Indicator, Sinisa Hristov |
---|---|
Next by Date: | Re: [TenTec] ALC Indicator, Bob Henderson |
Previous by Thread: | Re: [TenTec] ALC Indicator, Bob Henderson |
Next by Thread: | [TenTec] ALC Indicator, Frank Skinner |
Indexes: | [Date] [Thread] [Top] [All Lists] |