Here is a product ready-made for that task:
http://www.qth.com/topten/bdecoder.htm
73
Rick
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Bob Henderson
Sent: Tuesday, May 18, 2004 11:39 AM
To: tentec@contesting.com
Subject: Re: [TenTec] Yaesu FL-7000 to Orion
Don
Not quite.......to interface the Orion to the FL7000 for auto
band
change you will require some logic to make the interfaces
compatible.
This will take the form of a 16 to 4 line encoder of some type.
Definately not just a cable. If you are not familiar with binary
logic
yourself you'll need to enlist the help of someone local to you
who is.
I hope I've clarified that for you.
73 Bob, 5B4AGN
Don wrote:
>Bob
>
>
>"It is possible to auto band change the FL7000 or other Yaesu
amp from
>the Orion but not without an encoder to produce compatible band
data.
>
>Yaesu provide binary parallel band data from their radios and
that is
>what the FL7000 uses for auto band switching."
>
>So if I understand this correctly to "auto" band switch all I
should have to do
>is make up the cable? Just want to confirm that I am reading
correctly.
>
>thanks
>
>Don kd6hq
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|