Yep. One time I had the headphones on, pushed the PWR button to adjust power
output and this horrible, loud, mucho DB racket made me rip off my
headphones. My ears were ringing! Turning the rig off and one got it calmed
down.
The NR is tremendous. It's 100 times better than the PRO2's NR. However,
last night it quit working for no obvious reason. I "rebooted" and it
started working "sorta" but weakly. I had about given up until just a couple
of hours ago. I was surfing through the menu and turned on the "hardware nb"
feature. Suddenly the NR came back full force and it's back to it's amazing
self now. I turned off the hardare nb, no change, Turned it back on, no
change. weird..Did Microsoft help design this?
Steve
N4LQ
----- Original Message -----
From: "William H. Hein" <Bill@AA6TT.com>
To: <tentec@contesting.com>
Sent: Saturday, May 08, 2004 6:35 PM
Subject: [TenTec] "random" Orion bugs
N4LQ posted: "Yesterday I was almost finished with a qso and everything
went nuts. I had to 'reboot' and I was not in the split mode either. This
morning I lost receive audio a couple of times but it suddenly returned. I
went ahead an did a full reset just to flush out any bugs."
I am running v1.369 and have been bothered by the following bugs:
(1) Sub RX audio has buzzsaw noise but no signals
(2) VFO A will not tune Main RX but does receives signals OK (if it happens
to be tuned to a frequency with a signal)--turning the VFO knob does not
change the RX frequency although the frequency readout does change.
In both cases, cycling the rig's power cures the fault (temporarily).
I cannot ascertain any particular rig state that triggers these faults. I
do, however, tend to use the band scope.
73,
Bill NT1Y
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|