Press "MENUS" then "FILTER", and then you will see the top line is labeled
"Xtal Filter"... Turn the Multi Knob to select which filter you want to
use... 20 is the widest and is supposed to be the one with teh lowest
insertion loss, thus the best choice for weak signal work... But as I have
learned, the main receiver also receives any signals 14kHz down at the same
time....
As far as entering a frequency on the keypad, I haven't noticed any problems
except that I still do not understand how the stacking registers work...
----- Original Message -----
From: "Steve Ellington" <N4LQ@igLou.com>
To: <tentec@contesting.com>
Sent: Saturday, May 08, 2004 10:07 AM
Subject: Re: [TenTec] Cooling the Orion
> I didn't even know this had a 20khz filter Tom. Am I missing something? I
> did notice that when I enter a freq. on the keypad it doesn't always
> activate unless I turn the vfo knob. What's with that?
> Steve
> N4LQ
>
> ----- Original Message -----
> From: "Thomas Uhlman" <tuhlman@kimbanet.com>
> To: <tentec@contesting.com>
> Sent: Saturday, May 08, 2004 12:47 PM
> Subject: Re: [TenTec] Cooling the Orion
>
>
> > Speaking of Orion irregularities, has anyone noticed this issue:
> >
> > Set both receivers to the same band and same antennas....
> >
> > Enable the 20 kHz filter...
> >
> > Tune in a signal on the sub-receiver....
> >
> > Set the main receiver 14 kHz ABOVE the subreceiver frequency.....
> >
> > Do you receive the same signal on both receivers??
> >
> >
> >
> >
> > ----- Original Message -----
> > From: "Tommy" <aldermant@alltel.net>
> > To: <tentec@contesting.com>
> > Sent: Saturday, May 08, 2004 8:38 AM
> > Subject: Re: [TenTec] Cooling the Orion
> >
> >
> > > Yes, that seems to be a surprising 'plus' to the extra cooling air
> > movement.
> > > Would be interesting to know if Jim/KH7M has noticed the same thing
> with
> > > his Orion.
> > >
> > > Tom - W4BQF
> > >
> > > ----- Original Message -----
> > > From: "Thomas Uhlman" <tuhlman@kimbanet.com>
> > > To: <tentec@contesting.com>
> > > Sent: Saturday, May 08, 2004 8:15 AM
> > > Subject: Re: [TenTec] Cooling the Orion
> > >
> > >
> > > > Funny you mentioned the darkening of the left hand side of the
> > display...
> > > My
> > > > Orion's display does that too after about an hour or so of
power-up...
> > > >
> > > >
> > > >
> > > >
> > > > > I'm really not 'pressurizing' anything, mearly generating a slight
> air
> > > > flow
> > > > > out of the top of the Orion through the speaker grill. The intake
> > ports
> > > > > would be mainly the ports on the bottom of the radio, especially
the
> > > ones
> > > > > under the front panel. With the fan speed cranked down so the fan
> > makes
> > > no
> > > > > noise, there is just a gently flow of air exhausted out the top.
> > > > >
> > > > > One side benefit I have noticed: the left side of my LCD screen
had
> > > > become
> > > > > slightly darker than the rest of the screen (about an inch wide,
> > > > > vertically), now that has completely cleared up.
> > > > >
> > > > > Tom - W4BQF
> > > > >
> > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > >
> > >
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|