That sounds like RF is getting back into the Jupiter and keeping it keyed.
Check all your coax shields for a good ground connection and all normal RFI
methods to alleviate the problem.
73,
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "doc kd4e" <kd4e@arrl.net>
To: <tentec@contesting.com>
Sent: Saturday, May 01, 2004 7:23 PM
Subject: Re: [TenTec] Jupiter Sticking in Transmit
> More info:
>
> I haven't tried connecting a PC at all yet.
>
> Just tried a master reset, no effect.
>
> The OS Version is 1.26 b7 11.11.2003
>
> It seems to happen on a longer transmit even
> into a dummy load.
>
> TX 90% various Mic settings 50-80% with
>
> Even if I disconnect the mic it remains stuck
> in TX.
>
> There is no indication that the ALC is engaging
> no matter how hard I drive it (100% mic-level
> bellowing into the mic -- it just sticks in TX
> after being run hard in TX for a few seconds).
>
> doc
>
> John Sheeley wrote:
> > Doc
> > Have you tried a master reset .
> >
> > 73
> > WB4QDA
> > John
>
> --
> 73, doc kd4e
> West Central Florida
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|