Not sure about the Delta II.... but a good source for luminesent back light
material is Miller Engineering.
It's rated at 140 to 225 volts, 400 to 1600 Hz. One 6 x 4 sheet of this
film made two new backlights for my Harris RF-350K and cost $22.95. Lower
voltages just mean dimmer backlighting. I used a 115 volt source on the
Harris for the original backlight and it's perfect. Fantastic stuff.....
they sell a small power supply that will run them off AA or AAA batteries if
you don't have a voltage source on the rig.... I'm sure you could tap it
into the radio somewhere. Works great for scanners etc too like the RS
Pro-2005/2006.
http://www.microstru.com/exp2.html Kit # 2504 and you can just buy the
sheet.
Mike Melland, W9WIS
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|