Thanks Phil...I thouht it was so obvious that it had been reported long ago.
At least I know my Orion doesn't have a memory snaffu!!!
----- Original Message -----
From: "Phil Howlett" <w9xx@earthlink.net>
To: <tentec@contesting.com>
Sent: Sunday, April 25, 2004 9:10 PM
Subject: Re: [TenTec] Orion & FSK
> Yes, it's been noticed a loooooong time ago and reported.
> W9XX
>
>
> ----- Original Message -----
> From: "Tommy" <aldermant@alltel.net>
> To: <tentec@contesting.com>
> Sent: Sunday, April 25, 2004 7:41 PM
> Subject: [TenTec] Orion & FSK
>
>
>
> I discovered something this weekend that I had not noticed before and that
I
> do not recall having been discussed here on the reflector before. Since
it's
> so obvious, it has probably been discussed, but I just missed it.
>
> If you go to the FSK mode, anytime you turn the 'CUT' control, the audio
> output of the Orion changes. Sometimes the audio drops down very low,
> sometimes it sounds like the mode has been changed, but there is no
> indication of such on the display. The change occurs when you move the
'CUT'
> from a '+' value to a '-' value or vise versa, in either low cut or high
cut
> position. What ever is changing is brought back to 'normal' by just barely
> moving the BW control.
>
> Has anyone else experienced this? If not, I maybe need to do a memory
reset
> and see if that restores the rig to normal operation. If others observe
the
> same thing, then it needs to be reported to Ten Tec to be put on a wish
list
> for fixes.
>
> Any comments/recommendations would be appreciated.
>
> Tom - W4BQF
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|