Yes, it's been noticed a loooooong time ago and reported.
W9XX
----- Original Message -----
From: "Tommy" <aldermant@alltel.net>
To: <tentec@contesting.com>
Sent: Sunday, April 25, 2004 7:41 PM
Subject: [TenTec] Orion & FSK
I discovered something this weekend that I had not noticed before and that I
do not recall having been discussed here on the reflector before. Since it's
so obvious, it has probably been discussed, but I just missed it.
If you go to the FSK mode, anytime you turn the 'CUT' control, the audio
output of the Orion changes. Sometimes the audio drops down very low,
sometimes it sounds like the mode has been changed, but there is no
indication of such on the display. The change occurs when you move the 'CUT'
from a '+' value to a '-' value or vise versa, in either low cut or high cut
position. What ever is changing is brought back to 'normal' by just barely
moving the BW control.
Has anyone else experienced this? If not, I maybe need to do a memory reset
and see if that restores the rig to normal operation. If others observe the
same thing, then it needs to be reported to Ten Tec to be put on a wish list
for fixes.
Any comments/recommendations would be appreciated.
Tom - W4BQF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|