If one remembers seeing the many "signal lines" that ran along beside of the
RR tracks, they had a insulator arrangement with a metal support in the form
of an X which was used to swap the conductors.
Bob, K4TAX
----- Original Message -----
From: "Bwana Bob" <wb2vuf@qsl.net>
To: <tentec@contesting.com>
Sent: Friday, April 16, 2004 9:22 PM
Subject: Re: [TenTec] 450 Ohm feedline
> Yes, even before bundled cable, when long parallel lines were run on the
> telephone poles, the wire positions on the poles were periodically
> interchanged. One wire was dropped under the other and crossed over to
> its opposite side by means of a "drop bracket".
>
> Hey! Maybe this is the solution to BPL interference: Make the power
> companies twist the power lines!
>
>
> 73,
>
> BoB WB2VUF
>
> JAMES HANLON wrote:
> >
> > Bob wrote:
> >
> > > Regarding twisting the feed-line, why do you suppose the phone company
> > > called it "a twisted pair"? Answer: because that what it was and it
was
> > > used to maintain symmetry and thus reduce induced voltage from
overhead
> > > power lines. Same applies here.
> > >
> >
> > I'm an old Bell Labs engineer, and I can recall being taught in our
"CDT"
> > (Communications Development Training) courses that the pairs were
twisted to
> > cut down on the cross talk from other pairs bundled into the same cable.
> > I'm sure it helped for power line induced voltage as well though.
> >
> > Jim, W8KGI
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|