TenTec
[Top] [All Lists]

Re: [TenTec] More about power supply for my Argo V

To: <larrylg1@roamer.net>, <tentec@contesting.com>
Subject: Re: [TenTec] More about power supply for my Argo V
From: "Edward Crawford" <w4wvw@msn.com>
Reply-to: tentec@contesting.com
Date: Wed, 14 Apr 2004 21:34:52 -0400
List-post: <mailto:tentec@contesting.com>
FB, Larry. I think you will be better off with the new supply. Better to be 
safe than sorry. No sense taking the risk with the new rig no more than the new 
supply costs. Good luck with the new station.

Ten-Tec sold an accessory or aftermarket over voltage protection circuit that 
was used in line with the 252/262 power supplies, model #1150, that killed the 
output of the supply in the event of high voltage conditions. No longer 
available from Ten-Tec but sometimes found on the used market. I have a 
schematic for one of these and info about building this OVP circuit yourself, 
courtesy of Pete, W6JFR. Just a handful of parts and could be done inline or 
inside the supply. Would be glad to copy this and send it to you if you like.
The 252/262's had over-current protection but at 18-20 amps. I suppose you 
could use a 7 amp Airpax circuit breaker inline to protect the Argo V in the 
event you were drawing high current thru the finals such as a high SWR 
condition.

I didn't know anything about this less than a year ago so we owe it all to the 
fine inhabitants of this reflector who are much more knowledgeable about this 
stuff than I'll ever pretend to be!

73. cul de ed w4wvw ... 
  ----- Original Message ----- 
  From: Larry Greenberg N5BEA<mailto:larrylg1@excite.com> 
  To: tentec@contesting.com<mailto:tentec@contesting.com> 
  Sent: Wednesday, April 14, 2004 2:46 PM
  Subject: [TenTec] More about power supply for my Argo V


  After reading Edward's comments, I  became aware of an issue wit my 252 M0.  
I phoned TT technical dept. and spoke to  a tech who actually repairs Argos. I 
was again informed that I should not use the power supply that I have.   So, I 
went ahead and orderd a new one.  Thanks again to Edward and all those 
responded, without the negative comments, I would not have been aware of a 
potiential problem.   Larry GreenbergN5BEA

  _______________________________________________
  Join Excite! - http://www.excite.com<http://www.excite.com/>
  The most personalized portal on the Web!
  _______________________________________________
  TenTec mailing list
  TenTec@contesting.com<mailto:TenTec@contesting.com>
  
http://lists.contesting.com/mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>