Get an ENCO machine shop catalog they have them..
Frank
WA5CWE
----- Original Message -----
From: "Steve Weber" <kd9bo@mac.com>
To: <tentec@contesting.com>
Sent: Thursday, March 25, 2004 10:52 AM
Subject: Re: [TenTec] Wire guage
> If a source is found, would you please post to the list? We had one at my
former emplyer (now in China) and it vanished into someone's toolbox.
Unfortunately not mine!
>
> 73 de KD9BO Steve
>
>
> On Wednesday, March 24, 2004, at 04:38PM, Bill Fulling
<w4njf@email.midflorida.com> wrote:
>
> >Hi folks,
> >Many years ago when I was in the Navy we were issued in our ET toolboxes
a wire guage-it was about 2 1/2' in diameter and was used sort of like a
spark plug gapper-was used to ID the AWG diameter of unknown wires(go-no
go).Does anyone know if these are still available;I'd like to buy one.
> >73 de Bill W4NJF
> >
> >_______________________________________________
> >TenTec mailing list
> >TenTec@contesting.com
> >http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|