Thanks to everyone who answered my post about the problem with the
SignaLink interconnection. Actually, as it turned out, I guess it
never worked on TX since I received the Orion about 5 days ago. I
pulled t he SignaLink and made a direct connection from the G5
computer to the Orion and it worked just fine (setting as shown on
page 42 of the manual). I knew then that it was not the radio.
TX was getting into the SignaLink as the red LED was lighting. I
turned up the TX internal control and also the AUX setting and
everything started working with it also.
In the end I decided to use the direct connection with the computer
without an interconnector. So right now I have both the SignaLink and
a RigBlaster (from when I had a PC) sitting in the closet. If I
decide to run Virtual PC on the G5 (if they every release it) I may
use the RigBlaster again.
Dick, N5XRD
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|