During the ARRL DX conetst, my 238 tuner showed signed of a non-elastic
dial cord.
Whe I cranked the cord all the way to the right (end), the pointer went
to the end stop and then came back to the left.
So I decided to take the plunge and replace the elastic with a spring,
which I had gotten from <forgot his callsign> here on the reflector).
Well, installation has been a nightmare. I can't seem to get it right.
The tension seems okay when I put the front panel back, but after a few
cranks around the dial, the same symptoms show up -- coming back left
after going all the way to the right, not going fully to the left again,
etc.
Can anyone help with step-by-step directions an/or pictures (which would
be great!)
Thanks in advance,
Eric W3DQ
Washington, DC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|