My information/book says pin #4 is +4 VDC.
73
Bob, K4TAX
----- Original Message -----
From: "edoc" <kd4e@arrl.net>
To: <tentec@contesting.com>
Sent: Sunday, March 14, 2004 9:58 PM
Subject: Re: [TenTec] Jupter
> Richard Hemingway wrote:
> > I don't know if this is what you want. TT mic wiring is:
> > pin-1 MIC
> > pin-2 GND
> > pin-3 PTT
> > pin-4 +9VDC
> > I think that it is the same as on the Orion and Omni's.
> > Dick, N5XRD
>
> That will get it done, greatly appreciated!
>
> --
> Thanks! & 73, doc kd4e
> West Pasco County, FL
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|