No, I never have any problems with RF in the shack at all. My antennas are
located 300 feet from the house. I run a hard line cable underground from
the house to the antenna control box. I relay switch all my antennas out at
the antenna box. This works quite well for me.
73,
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Mark Erbaugh" <mark@microenh.com>
To: <tentec@contesting.com>
Sent: Thursday, March 11, 2004 1:17 PM
Subject: Re: [TenTec] tighter filter for Jupiter
> Carl,
>
> Did you ever have any problems with RF getting into the 599zx? I don't
> think I have a problem with RF in the shack, but whenever I connected my
> 599zx with my Omni VI (opt 3) it would act like it was getting RF, i.e.
> muffled audio in the speaker during TX. Remove the 599zx and the muffled
> audio went away. I tried ferrite beads on the audio leads. They reduced,
but
> did not eliminate the problem. I also tried grounding one of the case
screws
> of the 599zx to the Omni and that didn't help. The 599zx is being powered
> through a RigRunner power strip with the same 12 v supply that drives the
> Omni.
>
> Mark
>
> ----- Original Message -----
> From: "Carl Moreschi" <n4py@earthlink.net>
> To: <tentec@contesting.com>
> Sent: Wednesday, March 10, 2004 5:39 PM
> Subject: Re: [TenTec] tighter filter for Jupiter
>
>
> > I used to run a Timewave DSP-599zx with mine. It worked very well and
> > solved all the selectivity problems. You just have to use an isolation
> > transformer to drive the outboard DSP unit because neither side of the
> > external speaker jack on the Jupiter is ground.
> >
> > 73,
> >
> > Carl Moreschi N4PY
> > Franklinton, NC
> > ----- Original Message -----
> > From: "Jason Buchanan" <jsb@digistar.com>
> > To: <tentec@contesting.com>
> > Sent: Wednesday, March 10, 2004 10:34 PM
> > Subject: [TenTec] tighter filter for Jupiter
> >
> >
> > >
> > > Does anyone know if there is a way to get a tighter filter for the
> > > Jupiter? I find myself trying to squeeze the bandwidth filter tighter
> > > than 300Hz. There are times I wish I had 100Hz! :-)
> > >
> > >
> > > 73 Jason N1SU
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|