[TenTec] Sweep Questions

["Richard Detweiler" <rdetweil@hotmail.com>]

Hi Fellow Orion users,

I am wondering if anyone else is having sweep lock up problems under V1.369 
of the micro code.

The rig only quits RX & TX when the Sweep locks up,

Next to the Send 2 button is a message "DSP T/O 0" message and the sweep 
display is blank.

Most of the control functions seem to work, but can not hear an signal, or 
transmit.

I use logging software that is polling the rig,  about every 500 ms.

This has occurred both During CW and SSB contacts.  Usually within 10 
minutes into using the sweep.

If no one else is seeing this, then perhaps I have a bad logic board,  If 
others are seeing this then I need to get a patch...

Thanks for your replies.

73's
Rich
K5SF

_________________________________________________________________
One-click access to Hotmail from any Web page ? download MSN Toolbar now! 
http://clk.atdmt.com/AVE/go/onm00200413ave/direct/01/

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec