There is a padder capacitor in the 206 calibrator to set the crystal at the
precise frequency.
You can probably use your Argonaut 509 to tune radio WWV on either 10 MHz or
15 MHz as follows:
------------------------------------------
How to receive WWV on 15 MHz.
1. Set Band Switch to 21.0 MHz.
2. Rotate main tuning dial so that the frequency readout is 21.000 MHz.
3. Tune the RESONATE control to the image frequency located fully CCW
(between the 3.5 and 7.0 markings).
4. If WWV is not heard, tune around this frequency a bit until it is
received, providing that the band is open.
5. Zero beat the WWV signal with the 206 calibrator.
To Receive the 10 MHz WWV signal, use the same procedure, but tune to the
image on the 28.0 MHz band. Frequency readout will be 28.0000 at the point
of WWV reception. Since 10 MHz cannot be fully peaked with the RESONATE
control, it requires that this control be set FULLY CCW and that a stronger
signal be present at the antenna terminals than the 15 MHz signal.
----------------------------------------------------------------------------
Good luck and 73,
Mike -N4NT-
----- Original Message -----
From: "carlos popelier" <carlos_popelier@yahoo.com>
To: <tentec@contesting.com>
Sent: Friday, March 05, 2004 2:05 PM
Subject: [TenTec] tentec 206 calibrator
> hi,
> just get a 206 calibrator,
> has any one experience with it, dont have user manual.
> how must it be used on a argonaut 509,
> is the freq stable or must or can it be adjusted inside.
> any hints welcome
> thanks carlos on6cn
>
>
> regards carlos popelier
> groeten carlos popelier
>
> my radio amateur call: on6cn
>
> ---------------------------------
> Do you Yahoo!?
> Yahoo! Search - Find what you're looking for faster.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|