Thanks Bob for very nice directions for tuning my centurion. John
kb2huk----- Original Message -----
From: "Robert & Linda McGraw K4TAX" <RMcGraw@Blomand.Net>
To: <tentec@contesting.com>
Sent: Monday, March 01, 2004 12:24 PM
Subject: Re: [TenTec] Plate amperes ?
> The plate current should be kept below 0.8A which is the lower end of
the
> "black line". Grid current should be kept below 260 ma which is the
lower
> end of the "red line" on the meter.
>
> With the transceiver in tune, adjust the amplifier TUNE control for max
> output and adjust loading for a final value of grid current between 240
and
> 260 ma. Then readjust TUNE for max output. Increase drive from the
> transceiver as necessary but so as not to exceed 260 ma of grid current.
> These numbers should produce some 1200 to 1400 watts output.
>
> 73
> Bob, K4TAX
>
>
> ----- Original Message -----
> From: "John" <brazos@rochester.rr.com>
> To: <tentec@contesting.com>
> Sent: Monday, March 01, 2004 11:11 AM
> Subject: [TenTec] Plate amperes ?
>
>
> Hi all ! I have a ten tec centurion and I need to know what value
should I
> keep the plate ampers on for good operation . I can not find a mention
of
> this in the manaul . thanks John
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|