Grant:
They haven't cured our 80/40 meter anomally yet. I've talked to a couple of
others and they don't have the problem.....strange, as Ten Tec didn't.
John N1JM
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Grant Youngman
Sent: Sunday, February 22, 2004 1:32 PM
To: tentec@contesting.com; orion@contesting.com
Subject: [TenTec] Orion 1.369 Features and general ruminations
I noticed a few additional POD features in 1.369. Sorry if this is
redundant ... I don't recall seeing anything about it, but I've been
basking with Hawaiian sea turtles for two weeks, and haven't paid
much attention to anything else :-)
F1-3 can now be set to "RIT/XIT Clear"
The POD encoder can also be set to XIT/RIT, BW, and PBT. When
set to PBT, however, it appears to do HI/LO cut instead, depending
on whether HI or LOW cut is selected by the main control -- doesn't
appear to work right if the intent was actually PBT. And the issue
that deals with the PBT numeric display when HI/LOW cut is used
hasn't been fixed yet.
I'd still like to see something like "." on the POD toggle the XM
tuning rate adjustment.
I know there are some other buggies and things that T-T has been
made aware of that haven't been fixed yet. Hope these get taken
care of sooner than later.
-------------------------------
Grant Youngman /NQ5T
http://www.globeking.com
nq5t@comcast.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|