Second question:
You must enable a filter for it to be used. When you enable an optional
filter, if you are in the automatic mode, it will be activated depending on
the dsp bandwidth. - i.e the 500hz filter will activate when the dsp
bandwidth is set to around 370hz or less. In the menu you can set it to have
a filter selected all the time. Something I hadnt realized, as I just read
the manual, that the 2.4khz filter doesn't activate, in automatic mode,
until the dsp bandwidth is set to 2000hz or below. Learn something new every
day, as they say.
73,
John N1JM
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Richard Detweiler
Sent: Thursday, February 19, 2004 1:59 PM
To: tentec@contesting.com
Subject: [TenTec] Orion spot ?
ok, for my questions,
for the Spot button, I see that it sets the side tone as well as the
frequence offset, For CW, I want to be sure that if I'm receiving a tone at
the same audio tone as the spot, then will the person hearing my signal on
the other end hear me at the same tone as his 'spot' offset as well?
Second question,
When the optional filters are set to enable:no, Are the "Optional" filters
'automatically' selected as the BW is adjusted? Does enabling the filter
set it to Always on? What happens when more than one are enabled?
More questions to follow, but want to take this easy.
Rich
K5SF
_________________________________________________________________
Take off on a romantic weekend or a family adventure to these great U.S.
locations. http://special.msn.com/local/hotdestinations.armx
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|