Dave, I did the same thing and it freaked me out as well. What you've done
is turned the autosweep function on. See page 3-4 or section 3.8 of the
manual.
Bill, AK5K
----- Original Message -----
From: "David E Kreinberg" <jmkdek@juno.com>
To: <tentec@contesting.com>
Sent: Friday, February 06, 2004 1:11 AM
Subject: [TenTec] Jupiter trouble already??
> Hello all,
>
> I received my new Jupiter from TT yesterday. I'm hoping I haven't
> discovered a problem already.
>
> After about two hours of listening, playing, and pushing buttons, I
> pressed the Sweep button. The sweep did its thing and displayed
> like it should, However, when I turned the tuning knob, the rig would
> go into sweep mode automatically again. I tried turning the knob several
> times, and each time the rig would go into sweep.
>
> I noticed this didn't matter what band or at what frequency size the
> sweep
> was set to (I set several different sweep sizes). After chasing this
> around for
> about 20 minutes, I resorted to a microprocessor reset.
>
> I played around for about a half hour more and nothing weird happened
> again. I'm
> sure hoping this was just a fluke.
>
> Has anyone else ever experienced this? BTW, the rig is brand new from the
> factory with latest rev. firmware.
>
> Thanks for an insight.
>
> 73 de Dave, NR3E
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|