Hi David,
As I'm about 2 days behind in reading the list email you
likely have received the answer to this. I suspect that you had
the sweep range set to the minimum, (2.4 Khz) and the auto sweep
set to on so that everytime you moved 2.4 Khz it would auto
update. When you did the master reset you reset to the factory
default which is think is 120 Khz range and auto sweep off. Go to
the menu and look about half way down for the sweep settings.
73 Jim K4CGY
--- "Kreinberg, David" <DKreinberg@necinfrontia.com> wrote:
> Hello all,
>
> I received my new Jupiter today. After playing around for a few
> hours, I used the 'Sweep' feature. It worked normally at first,
> but after using it a few times I noticed a problem.
>
> When I turned the tuning knob, the sweep function would engauge
> by itself. I tried different bands and setting different sweep
> frequencies, but the rig kept going into sweep mode every time
> I touched the tuning dial.
>
> I gave up after about 20 minutes and did a microprocessor
> reset.
> That seemed to get things right again. I'm hoping it was just
> a fluke.
>
> Has anybody run across this one before? BTW, the rig is brand
> new and has the latest firware update.
>
> Thanks for any insight.
>
> 73 de Dave, NR3E
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
__________________________________
Do you Yahoo!?
Yahoo! Finance: Get your refund fast by filing online.
http://taxes.yahoo.com/filing.html
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|