Many moons ago, I had the same "problem" with my Orion. Turns out, I was
trying to drive the AUX input from a high Z source and since the AUX input
is a low impedance, I had your trouble. Make sure you're using a low
impedance source and it should work just fine.
W9XX
----- Original Message -----
From: <K4IA@aol.com>
To: <tentec@contesting.com>
Sent: Saturday, January 17, 2004 4:34 PM
Subject: Re: [TenTec] Line input on Orion (PSK?)
> On a related issue:
>
> I am trying to drive PSK through the Aux input and find it requires me to
set
> the Speech Processor to 8 in order to get enough PSK audio to have any
> output. I have the Menus>SSB>Auxilliary input gain at 80 and the TX
source on AUX.
> I also have to set the computer outputs at maximum. This doesn't seem
right.
>
>
> The same setup has plenty of drive for my Field. In fact I have to reduce
> the drive to almost nothing on the Field.
>
> Any ideas?
>
>
> Radio k4ia
> Craig "Buck"
> Fredericksburg, Virginia USA
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|