Have an Orion here, and have been listening to 20 meter CW for the past 30
minutes or so. I am using an Heil ProSet; don't hear the clicks that many
are discussing....... The only mods made to the Orion since I have received
it in September are the firmware updates (with the latest December version
installed).
Ron ....... NU1U
Yep, my hearing is outstanding as recently checked in an annual medical.
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Billy Cox
Sent: Thursday, December 25, 2003 23:56
To: tentec@contesting.com
Subject: Re: [TenTec] Headphone clicks
>If you use 32 ohm or higher impedance headphones, you won't hear the
>click. I was just suggesting a way for you to continue to use the same
>headphones. I don't have the click in my headphones at all. They are
>32 ohm headphones.
If 32 ohms is the common 'standard' fine ... if not then this is a design
issue ... and a tragic oversight which leads to discussions such as this ...
if 'X' ohms is the more common 'standard' found in most shacks, then that
should have been a consideration of the design standard.
Recall at first, the TT response was that there was NO problem. <sigh>
At least TT did back off of that statement and then offer other alternatives
including changing the design of their production specs as of 05/30/03.
See .... http://www.rfsquared.com/Orion/sd565-01.pdf for details.
One of the never ending questions as to designs and standards is always
going to be ... Do we hold up production to get it as close to spec as we
can? ... or ... Do we release it, and make any running changes as needed?
I have been part of such decision making processes, and they are not fun.
You never have the perfect knowledge you need, and even with the use of such
tools as design and process FMEA ... 'bad stuff' still can slip by you.
<FMEA = Failure Mode and Effects Analysis>
That's what much of this boils down to, it's driven by simple economics and
marketplace demands. The Orion/SDR represents running changes.
Is this perfect? No, but this IS better than TT not releasing the Orion
until every possible problem or point of failure had been addressed.
... and ...
To their credit, Ten Tec did not chose a very common third option ... ignore
the reality and hope it just goes away ... sadly too many vendors today use
a similar rule for much of their 'customer support' for too many items.
Happy Holidays to ALL,
73 Billy AA4NU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|