TenTec
[Top] [All Lists]

Re: [TenTec] Omni V Power Output Adjustment Question???

To: <tentec@contesting.com>
Subject: Re: [TenTec] Omni V Power Output Adjustment Question???
From: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>
Reply-to: Steve Baron - KB3MM <SteveBaron@StarLinX.com>,tentec@contesting.com
Date: Mon, 22 Dec 2003 02:24:06 -0000
List-post: <mailto:tentec@contesting.com>
What does the previous owner say ?

There is an adjustment.

----- Original Message ----- 
From: <OTAKEBI@aol.com>
To: <tentec@contesting.com>
Sent: Monday, December 22, 2003 02:17
Subject: [TenTec] Omni V Power Output Adjustment Question???


> I bought an Omni V and I notice that I am getting only about 75 to 80
watts
> out of it on all bands with RF power full clockwise.
> I show this on my outboard meter which shows my Corsair II putting out 100
> watts on all bands.
> The Omni shows 100 watts on its own meter.
> When I got my Corsair II I had to make adjustments to the low level driver
> board to get 100 watts output on my Bird meter.
> It was done by adjusting R15 and R11 while on 14.05.
> I just followed the Corsair II manual instructions and I was done.
> However, the manual of the Omni V is not as good as the Corsair's and does
> not show any such adjustment.
> Does the Omni V have an internal ALC adjustment?
> Can the RF output be increased like on the Corsair II or is it non
adjustable?
> Thanks,
> Dan N4VET
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>