To: | tentec@contesting.com, orion@contesting.com |
---|---|
Subject: | [Orion] Good news from K1EA re Orion CT fans! |
From: | Bill Tippett <btippett@alum.mit.edu> |
Date: | Sun, 23 Nov 2003 12:33:49 -0500 |
List-post: | <mailto:orion@contesting.com> |
Yippee! Just in time for CQ WW CW! Thanks to Ken K1EA. 73, Bill W4ZV [ct-user] CT9.92 with TenTec Orion Support http://lists.contesting.com/archives//html/CT-User/2003-11/msg00059.html
By the way, I liked using the Orion better than I thought I would. I ran some Europeans on Saturday in the LZ contest and found it very easy to get used to. Also, programming CT to interface it was very easy, which I appreciate very much. * PTT now works with paddle sending. You should not need to turn on your vox on CW. The important text commands are: PTTDELAY - set the delay from ptt to first keydown in milliseconds. A good number is 20 for most amps PTTHANG - set the time the ptt stays asserted after you stop sending. This is in baud (dot times). A good number to start with is 5. This is the equivalent of vox delay on your radio. * The repeat function in CW finally works properly again. If you are in repeat mode and press F1 (or anything else) while the waiting for the next CQ to start, it starts right away. This has been broken for a while. * The TenTec Orion is now supported.
|
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [TenTec] More to Orion vs Icom 756PRO II, W0YG Charlie Summers |
---|---|
Next by Date: | Re: [TenTec] How do I do frequency calibration?, W3UIO |
Previous by Thread: | [TenTec] More to Orion vs Icom 756PRO II, W0YG Charlie Summers |
Next by Thread: | [TenTec] FS Ten Tec Triton IV, K8bvj |
Indexes: | [Date] [Thread] [Top] [All Lists] |