Re: [TenTec] Freq readout

[Clark Savage Turner <csturner@slonet.org>]

Hey Paul -

I'll buy it back from you now!  Hi Hi Hi.

It is a simple problem, and I believe I had fixed it on yours before I 
sent it to you.  Lasted a few years anyway!

The display unit is on a separate small board.  The individual display 
LED's are on a separate piece with pin connections on a vertical bus, 
vertical against the front panel.  Carefully move it up and shoot a 
little DeOxit into the connections, then make sure all grounds around 
there are solid, move everything around a little, and reseat.  It should 
be good for another couple of years.  That is my experience, I just did 
this procedure on my Corsair II a little while ago.

Clark
WA3JPG


On Saturday, November 15, 2003, at 08:15 PM, Paul DeWitte K9OT wrote:

> I am having a problem with the freq readout on my Corsair II. I am 
> wondering
> if it is heat related, and I think that I have seen posted on here some
> mention of something that you can spray on individual parts to cool 
> them off
> and see if it is a heat related problem.
> Hope that I stated this so it is understandable.
>
> Thanks for any help
> 73 Paul K9OT
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec