I use my logging program, DXbase.
Freeware that does this is CWType, written by UA9OSV. You can read about
it at www.dxsoft.com. I haven't used it since it requires a slightly
different software interface than DXbase, which I'm set up to do.
Interface instructions are included in both programs, and may cost $5
max, depending on your junkbox.
Jim N4AL
William Evans wrote:
What software/hardware combinations are some of you using to interface
your rig with the computer so that CW (and hopefully other digital
modes) can be manipulated by someone with short, fat fingers that
sometimes quiver and shake? What would be the best way to interface the
two without a large outlay of cash? Your answers and help will be
greatly appreciated.
73
Bill, W4ISH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|