I actually drilled two 3/8" (I think) holes through my stucco/frame walls
and used two WWII surplus feed through insulators. I replaced the threaded
shafts with 12" or so brass ones from Home Depot. I enclosed the brass
shafts with Home Depot clear Lucite (I think??) tubing for insulation.
When I sell the house, it's just spackling compound and paint.
Jim N7US
----- Original Message -----
From: "MIKE BRYCE" <prosolar@sssnet.com>
To: <TenTec@contesting.com>
Sent: Sunday, October 19, 2003 5:11 PM
Subject: [TenTec] 450 ohm open line feed with ten tec tuner
boys and girls..
several questions....
I just put up a center feed zepp with 68 feet of wire on each leg. Feeding
with 450 ohm open line..
now, it's been a while since I've used open line, but any ideas on how to
get it into the shack?
and, should I use a external balun with the 238 tuner to keep the open line
outside the shack?
or would the internal balun work better? but have the feed line inside the
shack?
Mike Bryce, WB8VGE
SunLight Energy Systems
http://www.seslogic.com
http://www.theheathkitshop.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|