I have the same radio....the bandswitch knob is prone to spltting on the
inside...easy fix. What I did was put a small steel wire loop around the
outside of the part that goes on the shaft. Also, try switching the aux
reciever switch back and forth a few times. there is a known problem with
that particular switch not making contact.
----- Original Message -----
From: <OTAKEBI@aol.com>
To: <tentec@contesting.com>
Sent: Saturday, September 20, 2003 1:36 PM
Subject: [TenTec] Curiosity Question
> Does anyone know where to go to find a replacement for the bandswitch on a
> Corsair II.
> I was told at Ten Tec that they no longer supply the bandswitch.
> Mine has a little play in it and I was told it was caused by wear.
> The switch snaps right into band but I can wiggle the switch.
> I found the play to be in the part of the unit against the faceplate and
not
> in the wafers.
> I also checked set screws. They are fine.
> It seems like this is normal play but Ten Tec says it is wear.
> We may not have been communicating very well land line and all.
> The boys at Ten Tec say I should have a standby.
> They told me it is no big deal to find one.
> Yea, right!!!
> Can anybody with a Corsair II tell me what there experiences have been
with
> this problem.
> Dan
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|