HiBob
Did you check the bias current on the tubes?
Ron
K3MIY
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Robert & Linda McGraw
K4TAX
Sent: Thursday, August 21, 2003 5:45 PM
To: Tentec@contesting.com
Subject: [TenTec] AMP Question
While running a Tentec Centurion at about 275 watts carrier output, the DC
input is some 2800 volts at about 300 ma plate current or about 840 watts or
so input. I notice that the 3-500Z's show very little color on 75 M.
However, just noticed that with the same operating conditions on 40 M that
they show a good bit more color even though the DC input is the same and the
RF output is the same. Both tubes show about same amount of color.
Any clues as to why?
73
Bob, K4TAX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|