The argonaut V runs at 1200 baud. The Jupiter and Orion run at 57600 baud.
Is there a way to change the baud rate in MixW? In other words, can you
configure MixW for a Jupiter and also set the baud rate to 1200?
Carl Moreschi N4PY
----- Original Message -----
From: <duffyb01@fuse.net>
To: <tentec@contesting.com>
Sent: Wednesday, July 30, 2003 10:41 AM
Subject: [TenTec] MixW and use with Orion and Argonaut V
> I sent Nick an email about enhancing MixW to control the Orion and the
Argonaut V. I also sent him files related to the PC control of the Orion
and the Argo. This is what Nick said:
>
> >>>Hello Duffy,
>
> Please try "Jupiter (enhanced PC control) with
> Argonaut - V and ORION
>
> The documentation says that Jupiter, ORION and Argonaut have same commands
> for frequency and mode control.
>
> Please let me know the result.<<<
>
> O.K., so I tried it as suggested with the Argonaut V and simply cannot get
it to work. I have used the same settings that I use with my Jupiter and
MixW is simply unable to control the Argo. Can anyone else give this a
shot? Does anyone else have any suggestions as to why it is not working?
The N4PY software works perfect with the Argo, but cannot get the same
result with MixW.
>
> Anyone up to the challenge?
>
> Regards,
>
> Duffy
> www.wb8nut.com
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|