Okay; thanks Al and everyone--I think I have it figured out. I dismissed
the tap off the wire technique because I thought the bulb filament R would
be so high, nothing would go through it if the feedline wire were left
intact. I see now that the trick is to use tiny bulbs with lower filament
resistance. My feed wire is insulated. There was a time when you could get
bare wire feedline with ceramic spacers but I have not seen that for a long
time. I was told it isn't made anymore because of liability risks
(naturally). Unless I'm mistaken, if you want bare wire feedline now you
have to make it yourself. Be sure to get it high enough to keep some yahoo
from grabbing hold of it and suing you.
Rob Atkinson
K5UJ
Middle-aged Crank
From: "Alfred Lorona" <w6wqc@dslextreme.com>
Reply-To: "Alfred Lorona" <w6wqc@dslextreme.com>
To: <tentec@contesting.com>
CC: <k5uj@hotmail.com>
Subject: Re: [TenTec] balanced feedline light bulb test
To: <tentec@contesting.com>
Date: Tue, 15 Jul 2003 14:29:41 -0700
No. No need to open the feedline. See the reply by Stuart Rohre, Balanced
Feedline Light Bulb Test. He explained better than I could.
73. Al, w6wqc
_________________________________________________________________
The new MSN 8: advanced junk mail protection and 2 months FREE*
http://join.msn.com/?page=features/junkmail
|