Bill
It's half computer . hi hi . A master reset should
solve your problem . I have discovered with both my
Jupiter and Orion .They don't work quite right for me
unless I do a master reset after a firmware update .
I hope it works for you . The 60 meter update works
fine for me on both radios and yes I still can tramit
on 160
73
John de WB4QDA
--- Bill Fulling <w4njf@email.midflorida.com> wrote:
> Hello Gang,
> Downloaded Jupiter rev 1.24 Sunday PM and while it
> gave me Xmit on 60 mtrs(into a 50 ohm dummy load of
> course),
> I lost Xmit capibilty on 160;after a lot of intenal
> relay grinding(sounded like an old Gottlieb pinball
> machine racking up a big score!)lost 160 xmit
> capability.Had it for a few minutes while the relays
> were cycling;tried reloading ver 1.23 but still no
> output.Went to Peg mode and no joy there either.
> Don't know what this new bug is but I'm getting kind
> of tired of the Jupiter"s chronic fickleness with
> regard to any antenna that is is not R50-jx0 flat
> from DC to light along with a having to have a grond
> system that must meet lab specs.
> Will swap this hair puller straight up for a Good
> KWM2-A and I'll pay the freight both ways.
> Thank God T/T stayed out of the handheld
> business;its hard to say "Your antenna is too close
> to your rig-that"s why its acting goofy!"(Maybe I
> can let my next door neighbor put my antenna system
> on his roof,so my Jupe might work once in a while!)
> 73 de W4NJF
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com
|