TenTec
[Top] [All Lists]

[TenTec] Orion Died?

To: <tentec@contesting.com>
Subject: [TenTec] Orion Died?
From: wb4qda@yahoo.com (John Sheeley)
Date: Mon Jun 30 11:44:46 2003
Jim 
 I have had the same problems a time or two.After the
flash falure and master reset .I just turned the Orion
on and off a few times . Then I attempted to 
reflashed it . So far after atempting to flash  4 or 5
times it will finally take the firmware reinstall . at
least it has for me . 
73 
John de WB4QDA


--- Jim Reid <jimr.reid@verizon.net> wrote:
> Yes,  just a few minutes after I turned it on this
> afternoon,
> the view screen went blank!  Turned the rig off, 
> then on
> again after a few minutes.  Nothing.  Well,  the
> only buttons
> illuminated were TX on VFOB; the BW light,  and the
> LOCK
> light for VFOB.  No button would respond to a push, 
> nor
> pressing the illuminated buttons would do nothing.
> 
> So,  off again,  this time hold down the "MainRX/TX"
> button
> while turning on the radio to perform a Master
> Reset.
> It did,  came up on 20 meters;  I pushed the 40
> meter band
> button,  started to tune up to my frequency----blap,
>  and
> the screen went blank agian.  And back to the same
> buttons
> illuminated as above.
> 
> So,  I decided to go back to the update program and
> reinstall
> the 1.346 firmware again.  Program wouldn't run
> because of
> XP,  I guess. So unclicked the box which reads "Stop
> on Error"
> as that has worked to perform the updates in the
> past.
> This time the program started,  but then stopped
> with
> only 65 lines into the Orion;  but every few seconds
> the
> line count here on the PC would go up by 10 lines
> count,
> but no change on the Orion display.  So I waited
> awhile,
> with nothing happening on the Orion,  so turned its'
> power
> off again.  Tried again,  same result.  Tried
> another Master
> Reset......and,  no matter how long I sit here
> holding
> down the button,  the display just reads, "System
> Loading....".
> 
> So,  guess it is back in the box,  and back to
> Sevierville
> for a check out.  Wonder what happened??
> 
> Any ideas?  I probably messed up when I turned the
> rig OFF when it wouldn't continue the firmware
> reinstall,
> or maybe that was just another symptom of whatever
> failed inside the radio.
> 
> 73,  Jim  KH7M
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com
<Prev in Thread] Current Thread [Next in Thread>