The bandswitch on my Corsair II has a split in the center tube....try
putting a band of steel wire around the outside of the tube inside of the
knob. That works for me.
----- Original Message -----
From: "Mike Hyder --N4NT--" <N4NT_Mike.Hyder@charter.net>
To: <tentec@contesting.com>
Sent: Sunday, June 29, 2003 11:56 PM
Subject: Re: [TenTec] Need Corsair II knob!
> I've broken one or two knobs. The center tube that goes on the shaft
broke
> when I overtightened the setscrew. By putting a couple of book matches
> between the tube and the outer part, I've been able to shore it up to
> perform just like new (maybe even better).
>
> 73, Mike N4NT
>
> ----- Original Message -----
> From: "Don Rasmussen" <wb8yqj@yahoo.com>
> To: <tentec@contesting.com>
> Sent: Sunday, June 29, 2003 11:38 PM
> Subject: [TenTec] Need Corsair II knob!
>
>
> > Hi Guys,
> >
> > Can anyone tell me where I can find a single front
> > panel knob for the Corsair II mode control? It's the
> > same one used for the AF Gain, OFFSET, and most of the
> > other front panel controls. Any help on locating one
> > of these would be greatly appreciated.
> >
> > 73 es thanks,
> > Don Rasmussen WB8YQJ/6
> > Carlsbad, Ca.
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
|