Earlier, I wrote:
> My question: where is the TCXO alignment adjustment on the
> bottom of the Orion. I know I must remove the bottom plate,
> but where do I look, and what should I see? I assume the
> adjustment is somewhere on the A10 board, the Synth card.
> Special tool needed?
I believe this is a photo of the A10 board, upper left of this
inside, bottom view image:
http://www.n9vv.com/Images/Orion/orion-inside3.jpg
I can see both the #12 coax leaving the A10 card and going
over to the A2 rcv/con card; also the #19 (just barely) going
up top side to the A5 IFCNV card.
So, where is the TCXO adjustment? Maybe two possibilities:
the "shiny" silvery gadget with a hole in the top just below the
grommet through which the #12 coax is passing; or, that blue
colored gizmo maybe a couple inches above where the #12
coax is connected to the A10 card.
Am I close, hi?
73, Jim KH7M
|
