TenTec
[Top] [All Lists]

[TenTec] Some Observations on Orion Stability/Calibration

To: <tentec@contesting.com>
Subject: [TenTec] Some Observations on Orion Stability/Calibration
From: ghoffman@spacetech.com (Gary Hoffman)
Date: Wed Jun 4 16:55:20 2003
An electron ?  Or a wave ?


----- Original Message ----- 
From: "Mark Erbaugh" <mark@microenh.com>
To: <tentec@contesting.com>
Sent: Wednesday, June 04, 2003 3:05 PM
Subject: Re: [TenTec] Some Observations on Orion Stability/Calibration


> The late Rear Admiral Grace Hopper used to give out 'nanoseconds' at her
> lectures. They were foot long pieces of wire, indicating the distance an
> electron can travel in a nanosecond.  So I would guess that your delay is
> roughly 58000 nanoseconds.
> 
> Mark
> 
> ----- Original Message -----
> From: "Jim Reid" <jimr.reid@verizon.net>
> To: <tentec@contesting.com>
> Sent: Wednesday, June 04, 2003 13:56 PM
> Subject: Re: [TenTec] Some Observations on Orion Stability/Calibration
> 
> 
> >
> >
> > > This has given me some ideas for synchronizing signals
> > > around the shack,  including the use as an ultra-high stability
> > > reference for my RX-340....
> > > I just ordered the set from www.buylegacy.com
> >
> > Hmmm,  well I am tempted,  but....
> >
> > I live maybe 11 miles East of the WWVH antenna farm
> > here on Kauai.  I suspect the  ground wave signals I rcv
> > from them here have pretty good time accuracy,  hi.
> >
> > They are available at 2.5 (an omni antenna), 5, 10, and
> > 15 MHz from VH.  How many nanoseconds per mile at
> > light speed?  Doppler shift on ground wave?
> >
> > Is there a real point in my also ordering a GPS time standard?
> > Or,  should I spend the $350 to be sure?
> >
> > 73,  Jim  KH7M
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

<Prev in Thread] Current Thread [Next in Thread>