Carl,
The receive noise on the Omni does increase when I turn on the 1208.
Mark
----- Original Message -----
From: "Carl Moreschi" <n4py@earthlink.net>
To: <tentec@contesting.com>
Sent: Friday, May 30, 2003 15:18 PM
Subject: Re: [TenTec] Deaf 1208
> The 1208 should hear very well. You should hear a large increase in noise
> on 20 meters when you switch to the 1208. The front end transistor could
be
> blown if the previous owner accidetally transmitted 100 watts into it.
>
> Carl Moreschi N4PY
> Franklinton, NC
> ----- Original Message -----
> From: "Mark Erbaugh" <mark@microenh.com>
> To: <tentec@contesting.com>
> Sent: Friday, May 30, 2003 7:00 PM
> Subject: [TenTec] Deaf 1208
>
>
> > I have a TT 1208 6m - 20m transverter. I bought it used, but it is
labeled
> > as factory assembled. Last night, there was a 6m opening so I hooked up
> the
> > 1208 to my Omni VI. Granted, I don't have much of an antenna for 6m, but
I
> > could barely hear one or two stations. I switched the antenna to my Icom
> > R7000 receiver and heard a lot more activity. Granted most signals were
> > barely moving the S-Meter on either setup, but the R7000 definitely
heard
> > better.
> >
> > Is this to be expected, comparing a dedicated receiver to a transverter
> > (although the transverter has a pretty hot receiver hooked up to it in
the
> > Omni VI), or do I need to look at realigning or otherwise adjusting the
> > 1208?
> >
> > Mark
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|