You're not getting the correct presets to the counter.
On 80 and 40 a one should be preset by diode D7 on the
"Preset Amp Board" (80465). Check this diode and the
other diodes and transistors on this board.
73, Dave,VE1ADH
--- Blky4u@wmconnect.com wrote: > I recently
purchased a Omni D series C that is in
> really nice condition but
> there is a problem with the readout. When I first
> turn the radio on the leading
> didget is wrong.
> Example: 80 meters reads 2.xxx
> 40 meters reads 6.xxx
> The actual operating frequency is correct it is the
> readout only that is not
> right. After the radio is on for sometime everything
> works ok although it
> seems to be taking longer each time I turn it on
> which leads me to believe that in
> time it will not correct it self in time.
> I dont have a manual yet but the fellow I purchased
> it from is sending me one
> but if anyone has had this problem before I would
> like to hear from you or if
> anyone knows where to start looking.
> I have always gotten very good info from this
> reflector so let me say tnx
> in advance because I know someone out there knows
> how to fix this problem.....
> I know I can send it to TT but I would like to fix
> it if I could.
> Tnx agn es 73 de Bill KY4U
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
______________________________________________________________________
Post your free ad now! http://personals.yahoo.ca
|