There is a parameter to correct for the rx320 frequency error. Under the
settings menu, go to "Preferences4". Once there you will see a box labelled
"2nd Receiver Frequency Correction". Just put in the correct value here.
It should be the error in frequency at 10 mhz for the rx320. This value is
adjusted internally for other frequencies. One word of caution - the rx320
drifts a little and this value can change as the rx320 warms up. The rx320
should be on for 30 minutes when you decide on its value. I use LSB or USB
on WWV at 10 mhz to determine the error.
You may also need to correct for error on the pegasus although the peg is
never off anywhere near as much as the rx320. You can use "calibrate" to
get the peg dead on. See the pegasus.txt write up.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Jim Crooke" <crooke@crooke.us>
To: <tentec@contesting.com>
Sent: Thursday, May 29, 2003 8:06 PM
Subject: [TenTec] Peg/Rx320
>
>
> I got around to plugging in a nice used RX320 last night and using it as a
> subreceiver with my Pegasus using Carl's great software. It looks like it
> will be a nice combo for me. The only problem I've hit so far that has me
> stumped is the freq on the 320 is 100 hZ off of the Peg freq. I've tried
> changing the freq offset on the 320 and it made no difference. It got
late
> and I quit messing with it. Anybody know right off of the bat what I'm
> doing wrong before tonight's late night troubleshooting?
>
>
>
> 73 es oo de Jim KJ0C
> Healer of Brachycephalics and other fine looking creatures
> in Springfield, MO
> FP # -108 and semi-official veterinarian of the Flying Pigs QRP Club
> PITA #2 SOC #37
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|