Take the digital display apart enough to unplug and re-seat every circuit
board. Then, while you are at it, do the same with every circuit board in
the rig. Most troubles can be rectified this way.
73, Mike N4NT
----- Original Message -----
From: <Blky4u@wmconnect.com>
To: <tentec@contesting.com>
Sent: Tuesday, May 27, 2003 10:44 PM
Subject: [TenTec] Omni "C" readout
> I recently purchased a Omni D series C that is in really nice condition
but
> there is a problem with the readout. When I first turn the radio on the
leading
> didget is wrong.
> Example: 80 meters reads 2.xxx
> 40 meters reads 6.xxx
> The actual operating frequency is correct it is the readout only that is
not
> right. After the radio is on for sometime everything works ok although it
> seems to be taking longer each time I turn it on which leads me to believe
that in
> time it will not correct it self in time.
> I dont have a manual yet but the fellow I purchased it from is sending me
one
> but if anyone has had this problem before I would like to hear from you or
if
> anyone knows where to start looking.
> I have always gotten very good info from this reflector so let me say
tnx
> in advance because I know someone out there knows how to fix this
problem.....
> I know I can send it to TT but I would like to fix it if I could.
> Tnx agn es 73 de Bill KY4U
|